Welcome Inventors! If Thomas Edison had a blog, do you think he would write about his failed light bulb attempts? I do. Today’s post is not pretty, but I’m sharing it because sometimes the best lessons come from the belly flops and face plants.
I recently went to a play gym where there were bean bag launchers. Talk about fun! I wanted to buy one, but the supervisor said I could make one if I’m handy with a jig saw. Turns out “handy” is a relative term.
The launcher works – don’t get me wrong. So, if you want to give this a try, pull out a jig saw, an electric drill, some pallet wood (or whatever kind of wood you have handy) and sharpie. Measuring tape also helps, a mason jar lid, and a handful of screws. Be safe!
Cut a board of wood about 2 feet long and 4 inches wide (above). I just cut a board off of the pallet, but you do what works for you.
Take your mason jar lid, and mark it at the half-way spot on both sides. I made a line all the way down the side so there was blue on the front and the back.
Use your lid to make two semicircles on another piece of wood. Trace the outside, and cut along the lines you made with your jig saw.
Measure and mark your long board so that your two semicircle pieces are exactly in the middle. Space them a about an inch from the outside edge respectively. This gets a little bit tricky. I guessed with this part and it worked out fine.
Choose screws that are the appropriate size to attach the semicircles to the board. That was my fail. I knew the longer screws were risky, but I thought if I put them in at the right angle I’d be in the clear.
Two screw tips popped out the top of my launcher. Ouch. So, I cut a little piece of wood and put it on the top to make it more safe. Then one of the screws split the extra piece of wood.
What do we know is always true? When all else fails: duct tape!
The good news: this puppy works! My turkey bean bag can fly! Mishap modifications are all part of the fun of inventing. Not everything is going to go the way you plan the first time. Or maybe ever. Don’t let the belly flops keep you from learning how to dive.
[wpvideo 6PJsGgAP]
Thank you for sharing your time and any comments! Until next time, enjoy this imperfect, beautiful life and invent YOUR story!
Welcome inventors! This past week was spring break, and to celebrate I bought a box of springs. After brainstorming with my kids, we created our own spring-action race car launchers and gate. Check it out!
Here’s how we did it: First, we gathered all of the same size springs together. You could experiment with different strengths and sizes of springs, but in the spirit of good sportsmanship, we opted to keep them the same for racing. We used these materials and painter’s tape.
To make the launchers, we cut a paint stick into small pieces and sanded the edges. Then we super-glued (and doubled security with hot glue) the springs onto the back of our paint stick pieces. Launchers!
After that, we needed our starting gate. We ran out of hot glue, so we used painter’s tape to frame the sticks into stalls. This wasn’t hard, but the sticks moved quite easily.
The ends of the stalls were floppy, so we secured two screws together that faced opposite directions to the end of the starting gate to keep them equally separate. This is shown in the video at the end. We also taped the outside walls to our table.
Ready, set, launch! For our race, we used more painter’s tape to create a finish line for the winners. We also experimented with some interference for our race cars to navigate. My son made a display for our winning cars.
I think it turned out pretty well! Here’s our big race. Give it a try and see what you think. And whatever you do this spring, don’t forget to enjoy life and invent your story.
[wpvideo qbuoza9t]